Ground Concrete Stabilization Kit + Waterproofing and Paving/Stamped Concrete Sealer – SurfaPore FX WB + Monto Semi-Gloss Lacquer 4L

Product 1. Hardener for deteriorated or ground concrete, Stabilizer, SurfaPore FX WB, NanoPhos 1L

• Strengthens and densifies concrete – increases durability and extends surface lifespan.

• Effectively waterproofs – reduces water absorption and prevents penetration by aggressive agents.

• Deep penetration – small molecular structure for superior performance.

• Enhances abrasion resistance – minimizes efflorescence and concrete degradation.

• Hydrophobic protection – prevents water and moisture infiltration.

• Allows surface breathability – releases vapor without compromising protection.

• Natural appearance – does not alter the color or texture of the concrete.

• Protection against mold and dirt – reduces growth of moss, lichen, and deposits.

• High UV stability – does not yellow or fade over time.

• Eco-friendly water-based formula – odorless and VOC-free.

DIRECTIONS FOR USE:

Shake well before application to ensure homogeneity. Apply with spray, brush, or sponge roller. Do not dilute. Use a brush, roller, or airless spray gun. For absorbent surfaces, apply two coats; the second coat should be applied 15 minutes after the first. Remove any unabsorbed excess from the surface 20 minutes after application.

Estimated consumption rate is 1 liter per 6–8 m², depending greatly on the properties of the surface on which the product is applied.

PRODUCT 2: Sealer for Pavers, Concrete / Stamped Concrete, Waterproofing, Semi-gloss Finish, Monto, 4L

Benefits

Refreshes existing color – satin/wet decorative effect

Waterproofs against water, oil, wine, ketchup, etc.

UV protection and resistance to extreme temperature fluctuations

Prevents growth of moss, fungi, and mold

Conceals imperfections and restores a uniform appearance

Ready to use, with excellent adhesion on porous surfaces

DIRECTIONS FOR USE:

Clean the surface and test the product in a hidden area. Shake the bottle well, then apply the solution evenly with a roller, brush, or sprayer. Spread any excess after a few minutes and apply 2–3 coats, depending on the absorption level of the surface, following the recommended drying times. Avoid applying in direct sunlight. For low-absorption surfaces, use Water-Based Epoxy Primer, two-component, Epoxy Primer WB Nanophos, as a first coat.